Carbon Monoxide and Gas Heaters: Victorian Safety Rules and Detection Gu
Heating & Cooling

Carbon Monoxide and Gas Heaters: Victorian Safety Rules and Detection Guide

24/7 Service Mate · Heating and cooling advice team 9 min read

Carbon Monoxide and Gas Heaters: the short version

Infographic summarising the key points of Carbon Monoxide and Gas Heaters: Victorian Safety Rules and Detection Guide.

Carbon monoxide (CO) is a colourless, odourless gas produced by incomplete combustion in gas heaters, gas log fires, and gas water heaters. It is the leading cause of accidental poisoning deaths in Australian homes, and faulty gas heaters are the primary source in Victoria. Here's what every Melbourne homeowner needs to know.

Carbon monoxide emergency

If you or anyone in your home has symptoms of CO poisoning (headache, dizziness, nausea, confusion), leave the building immediately and call 000. Do not re-enter until emergency services clear the property. Call your gas retailer to disconnect supply.

Carbon monoxide (CO) is a colourless, odourless gas produced by incomplete combustion in gas heaters, gas log fires, and gas water heaters. It is the leading cause of accidental poisoning deaths in Australian homes, and faulty gas heaters are the primary source in Victoria. Here's what every Melbourne homeowner needs to know.

How gas heaters produce carbon monoxide

When natural gas (methane) burns completely, it produces COâ‚‚ and water vapour. When combustion is incomplete — due to a cracked heat exchanger, blocked flue, insufficient combustion air, or a faulty burner — carbon monoxide forms instead.

The most dangerous scenario: a gas heater with a cracked heat exchanger or a blocked flue operating in a poorly-ventilated room in winter, when all windows and doors are sealed for warmth. CO builds up gradually, and victims often fall asleep before realising anything is wrong.

Gas heater types and CO risk in Victoria

Heater typeCO risk levelNotes
Ducted gas heating (flued)Low if maintainedFlue exhausts combustion gases outside; annual service essential to maintain this
Wall furnace (flued)Low if maintainedRequires annual flue inspection and heat exchanger check
Open-flue gas heaterModerateDraws combustion air from room; flue downdraughts can back-draft CO into room
Unflued gas heaterHighAll combustion gases exhaust into room; banned in bedrooms and bathrooms under AS/NZS 5601; not suitable for enclosed spaces
Gas log fire (balanced flue)LowSealed combustion; draws outside air via coaxial flue

Victorian regulations and annual servicing requirements

Under Energy Safe Victoria guidelines, all flued gas heaters in Victoria should be serviced by a licensed gasfitter annually. The service must include:

  • Combustion analysis — testing CO output in flue gases and at the air inlet
  • Heat exchanger inspection — checking for cracks or corrosion
  • Flue integrity test — checking that all combustion gases exhaust correctly outside the building
  • Burner inspection and cleaning
  • Filter cleaning

Victorian residential landlords are required under the Residential Tenancies Regulations 2021 to have gas heaters serviced by a licensed gasfitter every 2 years (or as per manufacturer recommendations). See Consumer Affairs Victoria for the landlord compliance obligations.

Carbon monoxide detectors in Victorian homes

Unlike smoke alarms, CO detectors are not yet mandatory in Victorian residential homes. However, Energy Safe Victoria strongly recommends installing a CO detector in any home with a gas heater, gas log fire, or gas hot water system.

Detector placement guidelines

  • Install within 3m of each gas appliance (heater, hot water system, gas log fire)
  • At sleeping area level — CO detectors should be positioned in or near bedrooms because CO poisoning risk is highest during sleep
  • Not inside enclosed spaces where the detector cannot sample room air freely

Detector standards

Purchase a CO detector that meets AS/NZS 3197 (Australia) or EN 50291 (Europe). Detectors have a 5–7 year service life — check the manufacturing date on any unit you buy and replace on schedule. Most modern CO detectors also function as combination smoke/CO alarms.

Warning signs your gas heater may be producing CO

  • Yellow or orange flame instead of blue (normal)
  • Soot marks on or around the heater
  • Pilot light extinguishing repeatedly
  • Excessive condensation on windows when heater is running
  • Smell of gas (though CO itself is odourless)
  • Headaches or nausea that improve when leaving home or opening windows

What to do if your CO detector alarms

  1. Get everyone out of the building immediately
  2. Leave doors and windows open as you leave
  3. Call 000 from outside
  4. Call your gas retailer to disconnect supply
  5. Do not re-enter until emergency services confirm the building is safe
  6. Have the gas appliance inspected by a licensed gasfitter before reconnecting gas

Victorian legislation and carbon monoxide safety

Energy Safe Victoria requirements for gas appliance compliance

Energy Safe Victoria (ESV) is the statutory authority that regulates gas safety in Victoria. Under the Gas Safety Act 1997 and associated regulations, all gas appliances must be installed and serviced by licensed gasfitters. Landlords in Victoria are required to have gas appliances in rental properties serviced and safety-checked in accordance with the Residential Tenancies Regulations 2021 — this includes gas heaters. Tenants who suspect a gas appliance is faulty or producing unusual smells should contact the landlord or property manager immediately and, if there is any risk of a gas leak, call the gas emergency line on 132 771.

Carbon monoxide detector placement in Melbourne homes

Carbon monoxide is colourless and odourless — you cannot detect it without a CO detector. ESV and Fire Rescue Victoria recommend installing CO detectors:

  • In the same room as any gas heater, boiler, or gas log fire
  • In each bedroom if the sleeping area is near a gas appliance
  • Near a gas hot water system or gas oven in the kitchen

CO detectors are available from hardware stores ($40–$150) and should be replaced every 5–7 years as the sensor degrades. Combination smoke and CO detectors are available and efficient for bedroom placement. If your CO detector sounds its alarm, immediately move everyone including pets outside to fresh air and call the gas emergency line 132 771 — do not go back inside until emergency services confirm the area is safe.

Annual gas heater service as CO prevention

The single most effective action to prevent carbon monoxide risk from gas heaters is annual servicing by a licensed gasfitter. The heat exchanger — the metal barrier between the combustion chamber and the warm air distributed through the home — can crack over time from thermal cycling. A cracked heat exchanger allows combustion gases including CO to enter the home’s airstream. This fault is not detectable by the homeowner; it requires a technician to test. In Victoria, an annual gas heater service is mandatory for rental properties and strongly recommended for all homeowners. 24/7 Service Mate’s Andy and the HVAC team perform gas heater services across all Melbourne suburbs including a full heat exchanger visual inspection and combustion analysis. Call 1300 24 11 47 to book your annual service today and keep your household safe through Melbourne’s winter.

If you are a landlord in Victoria, ESV’s minimum service requirements for rental properties include gas heater servicing at the frequency specified in the manufacturer documentation, and at least every two years if no manufacturer guidance exists. Documentation of servicing must be kept and provided to tenants on request. Non-compliance can result in penalties under the Residential Tenancies Act. 24/7 Service Mate can manage your rental property gas heater servicing schedule and provides signed service records. Call 1300 24 11 47.

A licensed technician visit is the only reliable way to confirm your gas heater is operating safely this winter. Book with 24/7 Service Mate today — call 1300 24 11 47.

FAQ

Are CO detectors mandatory in Victoria?
As of July 2026, CO detectors are not legislatively mandatory in Victorian residential homes. However, ESV recommends them for all homes with gas appliances. Some local councils and rental compliance frameworks are moving toward mandatory CO detectors. Check with Energy Safe Victoria for the latest guidance.
How often should my gas heater be serviced in Victoria?
For rental properties: at least every 2 years under the Residential Tenancies Regulations 2021. For owner-occupied homes: annually — ESV recommends this frequency because annual servicing catches developing faults (cracked heat exchangers, partial flue blockages) before they become dangerous.

Gas heater service and CO safety check — Melbourne

Licensed gasfitters performing combustion analysis and heat exchanger checks across Melbourne. Call 1300 24 11 47.

For local help, see our Melbourne HVAC services, HVAC technician in Richmond, HVAC technician in St Kilda. Our gas heating installation and repair page covers scope, pricing and 24/7 dispatch. Emergency? See our emergency HVAC repair in Richmond. Related guides: Gas Heater Not Working? 7 Things to Check Before Calling, Gas heater service Melbourne: how often, what's checked, and the legal CO test.

Need a Melbourne heating & cooling technician?

We're one call away — 24/7 emergency service, live answer, upfront pricing.