Ducted heating vent in a Melbourne home delivering uneven airflow
HVAC

Ducted heating not heating evenly - zone setup mistakes most Melbourne homes have

Andy · Licensed HVAC Technician 6 min read

Ducted heating not heating evenly: what to check

Infographic: Ducted heating not heating evenly: what to check.
The top 3 reasons Melbourne ducted heating doesn\

The top 3 reasons Melbourne ducted heating doesn't heat rooms evenly: too many zones open at once dropping airflow pressure; the thermostat is positioned near a heat source so it shuts down early; or return-air vents are blocked by furniture. All three are fixable without a callout if you know what to look for.

How ducted zoning actually works

A ducted heating system has a single gas heater (or reverse-cycle compressor) and one main fan, pushing heated air through a network of ducts. Zone motors are flap dampers in the ducts that open or close based on which zones are turned on. The fan has a finite output - so opening too many zones at once reduces airflow to all of them.

Most domestic systems are sized for 2-3 zones running simultaneously. If you run 4-5 at once, every zone gets less air, and the rooms furthest from the heater suffer most.

Mistake 1 - too many zones open at once (pressure drop)

Check your zone controller. If you routinely have 4+ zones on, that's likely your problem. Fix: zone strategically. Living/dining + 1 bedroom for morning warm-up. Bedrooms only at night. The system was sized for grouped use, not whole-house simultaneous heating.

If you genuinely need all rooms heated at once, the system is undersized for the home. Adding a second smaller system or upgrading to a larger unit is the only real solution.

Mistake 2 - thermostat placed near a heat source

The thermostat reads ambient air temperature. If it's mounted on a sunny wall, near a kitchen, near a doorway from a heated area, or in direct sun through a window - it reads "warm enough" and shuts the heater off, even though other rooms are still cold.

Check: walk past the thermostat at different times. Does it sit in sun mid-morning? Is it near the cooking range? Beside the fireplace? If yes - relocation is the fix. A licensed HVAC tech can move it to a more representative spot for $180-$320.

Mistake 3 - return air blocked by furniture

Ducted heating needs a return air path. The system pulls air through one or more large grilles (usually ceiling or wall) and recirculates it through the heater. If a couch, bookshelf or rug blocks the return grille, the system can't move enough air through itself - and the rooms at the end of the run go cold.

Walk to every return-air grille. Make sure nothing is within 60cm of it. Clean the filter mesh if accessible (usually a wire frame with a filter).

Duct inspection - what to look for yourself

  • Visible squashed sections of flexible duct in the roof space (often from foot-traffic during cable work)
  • Disconnected ducts at outlets - a soft thump in the ceiling when the heater starts
  • Ducts not insulated - thin grey flex instead of foil-wrapped insulated ducting (efficiency loss)
  • Rodent damage to insulation, especially around the heater
  • Dirty filter at the return-air grille (clean every 3 months in heating season)

When it's a gas pressure or heat exchanger fault

If the heater rumbles, ignites then drops out repeatedly, or you smell gas/exhaust around the unit - stop using it and call. Heat exchanger cracks are serious (carbon monoxide leak risk) and unfortunately not uncommon in heaters over 12-15 years old. Gas pressure faults at the regulator can cause short-cycling and uneven output - a licensed tech can check inlet pressure during operation.

Gas heater service - how often Melbourne homes need it

Every 2 years for a healthy heater. Annually for any unit over 8 years old. The legal CO test should be part of every service. Cost: $260-$420 for a standard service including CO test. Read more in our gas heater service Melbourne post.

Cost of uneven heating diagnosis Melbourne

  • Service call diagnosis: $180-$320
  • Thermostat relocation: $180-$320
  • Duct re-secure and re-insulate per run: $220-$480
  • Zone motor replacement: $320-$520
  • Full duct system inspection with photos: $380-$580

Melbourne-specific ducted heating issues by home type

Federation and Edwardian homes with high ceilings

Melbourne’s Federation and Edwardian homes (pre-1920s) typically have 3.0–3.6m ceilings, ornate cornices, and minimal ceiling insulation. Ducted heating in these homes must work harder to overcome the heat stratification that occurs with high ceilings — warm air rises and stays near the ceiling while floor level remains cold. If your home has these characteristics and zoning feels uneven, increasing the fan speed setting (not just temperature) can help force warm air down into the living zone. Your HVAC tech can also redirect certain outlet vents to aim downward rather than across the ceiling.

Double-brick veneer homes in outer Melbourne suburbs

Double-brick homes built in Melbourne’s outer east (Box Hill, Ringwood, Mitcham) and outer south-east (Oakleigh, Clayton, Springvale) from the 1950s–70s are well-insulated by mass but can develop uneven ducted heating zones when the underfloor duct runs are long. Heat loss across a long run means rooms at the end of the duct run (often bedrooms furthest from the heater) get less heat. Balancing dampers at each zone outlet can redistribute airflow — ask your tech to check these during a service.

When to call a tech vs fix it yourself

Uneven heating that resolves by closing unused zones and checking return air vents is a DIY fix. Uneven heating that persists after adjusting zones, or that is accompanied by the heater cycling on and off more frequently than normal, or by a yellow/orange flame visible through the heater inspection window (should be blue), requires a licensed gas technician. Gas pressure issues, heat exchanger problems, and blocked flues are not safe to investigate without proper training and equipment. For Melbourne residents, Energy Safe Victoria’s emergency gas line is 1800 GAS GAS (1800 427 427) for suspected unsafe appliances. Call 24/7 Service Mate on 1300 24 11 47 for non-emergency gas heater servicing and fault diagnosis.

If you’re in an older Melbourne home with an ageing ducted gas heating system, a full duct inspection costs $120–$200 and often reveals simple fixes like damaged or disconnected duct sections under the floor that are easily repaired in under an hour. This is well worth doing before booking a zone controller replacement.

FAQ

Should I leave heating on all day at a low temperature, or only when I need it?
For Melbourne winters, run-on-demand with smart scheduling is more efficient. Modern controllers handle this automatically.
Why is one room always cold even with the zone open?
Most likely: disconnected or kinked duct in the roof. Visual inspection from the manhole usually finds it.
Can I add another zone myself?
No - requires duct cutting, motorised damper install and re-balancing. Licensed install.
Are smart thermostats worth it?
Yes for households with varying schedules. App control and zoning intelligence make a noticeable difference.
How much does a ducted system cost to run in Melbourne winter?
Gas ducted: $25-$45 per day with regular use. Reverse-cycle ducted: $15-$30 with efficient use. Depends on size and energy tariff.

Cold rooms in winter?

Call 1300 24 11 47. Same-week diagnosis with full duct inspection.

For local help, see our Melbourne HVAC services, HVAC technician in Box Hill, HVAC technician in Oakleigh. Our ducted air conditioning page covers scope, pricing and 24/7 dispatch. Emergency? See our emergency HVAC repair in Richmond. Related guides: Ducted Heating Service Cost Melbourne 2026: What Is Included, Ducted air conditioning installation cost Melbourne - full breakdown by home size.

Need a Melbourne hvac technician?

We're one call away — 24/7 emergency service, live answer, upfront pricing.