Calling an emergency electrician at 11 pm costs more than a daytime callout. Whether that cost is justified depends on whether the situation is genuinely unsafe to leave until morning. Here's the clear decision guide - and the 7 situations where you should call 24/7 regardless of the time.
Call now (don't wait until morning)
These situations require an immediate call to an after-hours electrician. Leaving them overnight creates a genuine risk of fire, electrocution, or loss of critical equipment:
- Burning smell from the switchboard, wiring, or an outlet. Electrical arcing or overheating in wiring is a fire risk. Leave the affected circuit off, do not continue using it, and call immediately.
- Visible sparking from a switchboard, outlet, or wiring. Active arcing. Turn off at the switchboard if it's safe to do so, then call.
- Total loss of power and the meter/switchboard is not the cause. If your neighbours have power and your switchboard looks intact, the fault may be in the service connection - call the network (Jemena or United Energy) first, then an electrician if the network confirms the problem is on your side.
- Flooded area with electrical equipment. If water has reached electrical fittings, outlets, or the switchboard area - do not enter the space, do not try to turn anything on or off in the wet area. Call immediately.
- Electric shock received. If someone has received a shock from a fitting or appliance, the circuit it was on should be turned off at the board. Seek medical attention. Then call an electrician - the source of the shock must be identified before the circuit is energised again.
- Safety switch tripping continuously with a dangerous situation in the home. If you cannot restore power and someone in the home is medically dependent on electrical equipment (CPAP, refrigerated medication, dialysis), call immediately.
- Smoke from a light fitting or roof space. Turn off the affected circuit. Call emergency services (000) first, then an electrician.
Can wait until morning (it's not an emergency)
- One circuit off, others working fine, no burning smell or sparking.
- A single light globe or fitting has stopped working.
- An outlet has stopped working but no smell or visible damage.
- Your air conditioner, oven, or appliance has stopped working but no safety concern is evident.
- You want a powerpoint added, light installed, or switchboard looked at.
Booking these jobs for a daytime appointment will cost you $150–$250 less than an after-hours callout for exactly the same outcome.
After-hours call-out costs in Melbourne 2026
| Time of call | Typical call-out fee | Hourly rate after first hour |
|---|---|---|
| Business hours (7 am – 5 pm Mon–Fri) | $120 – $180 | $110 – $140/hr |
| After hours (5 pm – 10 pm weekdays) | $180 – $280 | $140 – $180/hr |
| Late night and overnight (10 pm – 6 am) | $280 – $380 | $180 – $220/hr |
| Weekends and public holidays | $250 – $350 | $170 – $210/hr |
Most emergency jobs - a tripped safety switch traced to a fault, a burning outlet made safe, a flooded circuit isolated - are resolved within 1–2 hours. Budget for callout fee plus 1–1.5 hours of labour for a typical after-hours emergency.
What happens when 24/7 Service Mate responds
Our technician arrives with a full diagnostic kit - insulation resistance tester, RCD tester, thermal camera, and circuit tracer. The first priority is making the home safe: isolating the fault circuit, confirming the rest of the installation is secure, and providing a clear statement of what was found and what needs to happen next. Where parts are available on the van, full rectification is completed on the same visit.
Energy Safe Victoria requires that any work performed on the electrical installation in an emergency is still done to the standard of AS/NZS 3000 - emergency work does not relax compliance requirements. A Certificate of Electrical Safety is issued for any prescribed electrical work completed, even at 2 am.
Before you call - what to do right now
- If there is active sparking, fire, or someone has been seriously injured - call 000 first.
- Turn off the affected circuit at the switchboard (if it's safe to access).
- Do not touch any fittings, wiring, or switchboard components if there is water near them.
- Note the circuit number or label from the switchboard for the electrician.
- Note any sounds (buzzing, crackling) or smells that were present before the fault.
What an after-hours Melbourne electrician actually needs from you
When you call at 2 am, the response is faster and the job goes more smoothly if you can answer a few questions before the electrician dispatches. These are not bureaucratic hurdles — they help us bring the right tools and confirm the right scope for the call.
Describe the symptom precisely
“No power” covers a lot of ground. “Half the house has no power and the safety switch is tripped and won’t reset” tells us to bring an RCD tester, suspect a faulty appliance or wiring fault, and arrive ready for a circuit-level diagnosis. The more specific your description, the better prepared we are.
Tell us what you have already tried
Have you reset the safety switch? Did it trip immediately or stay up for a short time before tripping again? Have you unplugged all appliances? This sequence tells us a great deal about whether the fault is an appliance, an overloaded circuit, or a wiring fault. It also saves time on arrival if we already know the reset-and-trip sequence.
Confirm safe access
If the fault involves water ingress near electrical equipment, or if there is a burning smell with visible sparking, stay away from the affected area and confirm the access route to your switchboard. Let us know if the switchboard is in a garage, a locked utility room, or on an upper floor — this avoids delays on arrival.
Energy Safe Victoria’s electrical emergency guidance covers the steps to take while waiting for an emergency electrician to arrive.
FAQ
- Does 24/7 really mean 24/7 or will I get an answering machine at midnight?
- 24/7 Service Mate operates a live dispatch service around the clock. You'll speak to a person, not a voicemail, and a technician will be dispatched for genuine emergencies. For jobs that can wait, we'll book the earliest available daytime slot to save you the after-hours premium.
- What's the difference between calling an electrician and calling the power company?
- The network (Jemena or United Energy) is responsible for the power line from the street to your meter box. If their side of the connection has failed, they attend for free. Everything from the meter box into your home is your responsibility - that's what a licensed electrician attends to. If you're unsure which side the fault is on, call the network first; they'll tell you if the fault is yours.
- Will the after-hours fee be covered by home insurance?
- Some home insurance policies include emergency assistance cover that pays for an after-hours call-out. Check your policy document under "emergency assistance" or "emergency services" cover - this often has a per-incident limit. Keep the tax invoice as it will be required for the claim.
Related reading
For local help, see our Melbourne electrical services, electrician in Richmond, electrician in Melbourne CBD. Our emergency electrician in Richmond page covers scope, pricing and 24/7 dispatch. Emergency? See our emergency electrician in Richmond. Related guides: Electrician cost Melbourne 2026: call-out fees, hourly rates and what a fair quote looks like, Electrician Inner East Melbourne: Richmond, Hawthorn, Camberwell and Box Hill.