A basin that empties in a slow spiral is a partial blockage. Treat it before it becomes a standing pond. Hair and toothpaste in bathrooms, grease in kitchens. A plunger is one attempt, not a personality.
The short version
- Slow is a warning. Treat it before it becomes a standing pond.
- Bathroom basins: hair, soap scum and toothpaste in the trap and pop-up. Kitchens: grease and food scraps.
- One fixture slow: local. Several fixtures slow: shared branch or main line.
- Skip the caustic cleaner. It sits in a half-blocked pipe and can damage fittings and skin.
- If the same sink slows again within weeks, a camera beats another round of snaking.
How fast should it drain?
A basin of water should empty in under a minute with a gentle swirl and no gulping. A kitchen sink with a full bowl should clear in about the same time or slightly longer. If it takes several minutes, leaves a ring of scum or gurgles on the way out, the pipe is restricted. Try a timed test: fill the basin, time the drain, and note the time. Repeat after any DIY clean. A before-and-after number tells you if you made a difference.
Bathroom pattern
Hair is the main enemy. It wraps around the pop-up stopper and forms a mat that catches soap and toothpaste. Over weeks, the mat becomes a plug. In rental homes and shared houses, the build-up goes unnoticed until it stops. Hard water and soap create a scum that coats the walls of the trap and shrinks the opening.
Safe DIY steps: remove the pop-up stopper if it lifts out, pull out hair with a plastic drain tool or a bent coat hanger with care, wipe the stopper clean, and flush with warm water. Put a bucket under the trap before you loosen it. Photograph the arrangement first, and only unscrew slip nuts by hand. If anything is seized, corroded or glued, stop.
Kitchen pattern
Cooking oil cools and sets in the trap and on the pipe wall. Add food scraps and it becomes a paste. Dishwasher discharge may flush it along a few metres, then it sets again. Our full guide is in blocked kitchen sink in Melbourne. Quick checks: does the dishwasher outlet join the same trap, does the other bowl fill when you drain one, and does the laundry nearby also run slowly?
When slow means sewer
If a slow basin is joined by a slow shower, a slow laundry tub and a gurgling toilet, the restriction is probably in the main line, not at the basin. Roots, a sagging section or a collapsed joint in the property drain build restrictions that grow over months. After rain or a dry spell, the problem often worsens. Related: tree root blocked sewer, gurgling drain and sewer backup in the bathtub.
In apartments, a slow drain in several bathrooms may be a building stack problem. Tell your strata manager rather than ordering a call-out that cannot fix it.
Why after a renovation?
New bathrooms sometimes arrive with builder debris in the pipe, a trap with too little fall, or a basin waste that runs almost flat. A pipe fitted with poor fall holds water and catches solids. A vanity that fits snugly can also squash a flexible waste. We check the geometry as well as the blockage, and we correct it rather than clear it again and again.
What we do
We start at the trap, then work along the branch with the right tool: a small cable for a basin, a larger machine or a jetter for a longer run. After clearing, we run water to confirm flow, and if we found anything suspicious we put a camera into the line. We tell you plainly what we found: hair, grease, roots or a damaged pipe. Related: plunger vs drain snake vs plumber and chemical drain cleaner risks.
Cost guide for 2026
Guides only; we state the figure before we start.
- Clearing a basin or sink trap and short branch: usually a standard call-out plus labour, often a couple of hundred dollars.
- Clearing a longer line with a machine: commonly a few hundred dollars.
- Jetting for grease or scale: typically an additional few hundred dollars.
- CCTV inspection: often a few hundred dollars, useful for repeat problems. See blocked drain cost 2026.
- Replacing a worn trap or waste: modest, with parts included.
Melbourne suburb notes
In older Richmond, Brunswick and Northcote homes, bathroom wastes often run through a long horizontal branch to a stack at the back of the house, and the pipe may be lead-era or galvanised with a rough interior that catches hair. In 1990s project homes in Doncaster and Ringwood, the shared basin and shower line is often a narrow PVC with little fall. In newer townhouses, tight vanity cabinets squash flexible wastes. Each type has its own repeat pattern, and knowing it helps us choose the right fix.
Keeping it from coming back
- Fit a fine hair catcher in the shower and basin wastes, and empty it into the bin.
- Flush a kettle of hot, not boiling, water down the kitchen sink weekly after a good scrape of dishes.
- Avoid solid toothpaste blobs and shaving residue in basins, which set in the trap.
- Clean the pop-up stopper every month or two.
- If a sink slows twice in a month, book a camera inspection instead of another quick clear.
FAQ
- Is a zip-style boiling tap related?
- No. A boiling tap does not cause slow drainage. Watch for limescale on the tap outlet if you have hard water, which is a separate maintenance task.
- Can I use a cheap hand auger?
- For a basin trap, a small plastic drain tool is usually safer. A long metal auger can scratch or puncture a thin trap.
- Why after a reno?
- Debris, poor fall or a squashed waste. A good plumber checks the layout as well as clears the blockage.
- How fast should it drain?
- Under a minute for a basin of water, with no gulping or gurgle.
- Guide cost?
- See the guide above. We quote on the day and confirm before work starts.
- Does baking soda and vinegar work?
- It can freshen a trap but will not clear hair or set grease. Treat it as maintenance.
Related reading
See plumbing, blocked drain clearing, shower drain blocked, plumber in Richmond and plumber in Brunswick.
Basin draining slowly again?
We clear it and camera the line if it repeats. Call 1300 24 11 47.