Licensed Melbourne plumber working under a kitchen sink
Plumbing

Washing machine tap leaking in Melbourne? The 15-year-old laundry cock and the hose behind it

Steve · Licensed Plumber 5 min read

The taps behind a washing machine are cheap, forgotten, and under pressure 24 hours a day. A drip at the spindle, a leak at the hose nut, or a split hose is enough to flood a laundry. Pull the machine out before the skirting swells.

The short version

  • Turn the taps off at the wall, then at the stop tap if water keeps flowing.
  • A drip at the spindle is a washer or seal. A drip at the hose nut is a fitting or hose problem.
  • Pull the machine out and check behind and under it for hidden water damage.
  • Braided hoses fail with age and pressure. Replace on a schedule, not after a flood.
  • Apartments need extra care. A laundry leak can reach several neighbours quickly.

Tap vs hose vs machine

The taps behind a washing machine are cheap, forgotten, and under pressure 24 hours a day. A drip at the spindle, a leak at the hose nut, or a split hose is enough to flood a laundry. Pull the machine out before the skirting swells.

Sorting the source:

  • Water at the tap spindle (the handle shaft): a worn washer, gland packing or O-ring. Common on taps that are decades old.
  • Water at the tap body or wall: a corroded tap, or a leaking joint behind the wall. This needs a plumber, since there is a concealed pipe involved.
  • Water at the hose connection to the tap: a worn washer inside the hose nut, a cross-threaded nut or an overtightened plastic fitting.
  • Water at the hose connection to the machine: the machine inlet filter or seal.
  • Water along the hose body: a perished or split hose. Replace it immediately.
  • Water under the machine: check the drain hose, the pump filter and the door seal, because the leak may not be at the taps at all.

Why they fail

Constant pressure is the main cause. Mains pressure in Melbourne can reach well over 500 kPa in some suburbs, and a flexible hose sits behind the machine with that pressure on it all day. Rubber hoses perish, braided hoses corrode at the crimps, and plastic nuts crack. Hard water, vibration from spin cycles, tight bends where the machine presses the hose against the wall, and poor-quality fittings accelerate the wear. Taps in older houses were often cheap quarter-turn or screw-down types, fitted decades ago and rarely used. See pressure limiting valve and flexi hose failure prevention.

What to do now

  1. Turn off both taps. If the tap itself leaks and will not shut, turn off the water at the property stop tap and tell us. See how to turn off the water meter.
  2. Unplug the machine if the floor is wet. Never stand in water and touch power points.
  3. Mop and dry the area, and lift the skirting or look behind the cabinets for hidden water.
  4. Check the hose for bulges, rust at the crimps or cracks. If it is more than five years old, replace it.
  5. Photograph any damage for insurance.

Repair

We replace the tap washers or the whole tap, fit new hoses with proper washers, and test under pressure. If the tap is corroded onto the pipe or the wall pipework is galvanised and brittle, we may need to replace a short section. Fitting a washing machine tap with a lever handle and a hose with a burst-limiting device (some brands include a flow stop) adds protection. A pressure test of the laundry supply tells us whether the wider system is stressed.

If you have a stainless or plastic trough next to the machine, we also check its taps and waste, since a laundry leak is often more than one fitting. Related: leaking tap repair cost and tap replacement cost.

Cost guide for 2026

Guides only; we quote on site.

  • Replacing washers or seals on one tap: typically a call-out plus labour, often a couple of hundred dollars.
  • Replacing both washing machine taps with new quarter-turn taps: commonly a few hundred dollars.
  • New braided hoses: small extra, a good idea during any visit.
  • Repairing or replacing a short section of wall pipe: depends on access and wall type.
  • Repairing water damage to the floor or cabinets: separate. A flood leak may be an insurance matter.

Apartments and rentals

In an apartment, a leak from your laundry can damage neighbours below, and your owners corporation or insurer will want to know the cause. Use a licensed plumber and keep the invoice. Tenants should report a leaking tap to the landlord or agent promptly. Landlords are generally responsible for repairs to fixtures like taps. See rental urgent repairs in Victoria and strata plumbing services.

Hidden damage checklist

A laundry leak seldom stays in the laundry. Water runs along the floor to the nearest gap and wicks into skirting boards, cabinet bases, and the slab edge. In timber-floor homes, it drips into the subfloor, where it feeds rot and borers. Check these spots after a leak:

  • The base of the laundry cabinet and adjoining walls, for swelling or a musty smell.
  • Skirting boards and the flooring edge, for lifting or staining.
  • The ceiling below, in a two-storey house or apartment.
  • The underside of the floor in a raised house, if you can safely reach it.
  • Powerpoints near the washing machine. If they got wet, have an electrician check them before use.

Fans and open windows help drying, and a dehumidifier speeds it up. If in doubt, ask us to take moisture readings.

FAQ

Should I turn washing machine taps off after every wash?
It reduces risk, but many people forget. A braided hose in good condition on a pressure-limited supply is fine, and a tap that is easy to turn helps.
Hot and cold both needed?
Many machines use cold only, some use both. Check the model, and fit a tap for each inlet.
Can I swap a hose myself?
Yes if the taps are sound. Use new washers, hand-tighten plus a small turn with a spanner, and check for drips for 24 hours.
Insurance?
Sudden hose bursts are commonly covered. Gradual leaks often are not. Keep photos and receipts.
Apartments?
Tell your strata manager if water has gone below. We provide a report of the cause.
Can a leaking tap spin the water meter?
A slow drip adds up, and it can show on the meter test described in mains water leak.

See plumbing, leak detection and repair, dishwasher flooding, plumber in Malvern and plumber in Richmond.

Laundry tap dripping?

Fix it before the skirting swells. Call 1300 24 11 47.

Need a Melbourne plumbing technician?

We're one call away — 24/7 emergency service, live answer, upfront pricing.