If the water meter still turns when every tap is off, water is escaping on your side or the authority’s. A hiss in the front yard, a sudden high bill, or a strip of green in a dead lawn is enough reason to test the meter, not to start digging.
The short version
- Shut every tap, ice maker and the toilet fill. Watch the meter. Movement means a leak.
- Know the property stop tap. Using it is how you stop the bill and the sinkhole while you wait.
- The bit from the main in the street to the meter is often the water authority. From the meter in is usually you. We help you tell them apart.
- Do not drive over a growing wet patch in the crossover. It can collapse.
- Detection before excavation. We quote digging only after we know the line.
Signs of a mains leak
- A water bill far above your usual pattern, with no change in household habits.
- A hissing sound near the meter or the front of the house at night.
- A patch of lawn that stays green and boggy in a dry spell, or a sunken strip along the line to the house.
- Reduced pressure at every tap, with no change on the street.
- Water seeping through a driveway joint or the base of a front wall.
- A meter dial that moves with everything off.
Meter test
Take a photo of the dial, wait 30 minutes with nothing using water, photo again. Some meters have a leak indicator star or triangle that spins when water flows. If it moves, flow is leaving the meter. Related: how to turn off the water meter.
Before blaming the underground pipe, eliminate the obvious: a running toilet, a dripping tap, a leaking irrigation valve, a hot water system relief valve and a pool auto-filler. Close the isolating taps one at a time and watch the dial. If the meter stops after you close the hot water isolator, the leak is on that system, not the main.
Authority vs private
If the leak is under the nature strip before the meter, call your water retailer as well. If it is under your driveway after the meter, that is private plumbing. We locate and quote. We do not pretend a dye test on a garden tap finds a poly line under concrete. Yarra Valley Water, South East Water and Greater Western Water each manage their own network and publish how to report a street-side leak. Tell the retailer if you see water bubbling up in the road or the footpath.
Most retailers will fix a leak on their side of the meter at their own cost. Some also offer a one-off bill adjustment for a hidden private leak once it is repaired and evidence is provided, so keep our invoice and any detection report. Ask your retailer what documents they accept before you start.
How leak detection works
A skilled operator uses electronic listening equipment on the meter, the stop tap and the ground above the line, and often tracer gas or correlators on difficult runs. The aim is to narrow a leak to a metre or two before anyone picks up a shovel. On a long run under a slab, we may isolate sections with valves to find which half of the line leaks. Related: leak detection and repair and pipe burst water damage.
Repair options
Clamp, cut-in, or reline depending on pipe type (copper, galvanised, poly). Galvanised in older inner suburbs often means more than one hole. We say that if the pipe is original. In many Melbourne homes built before about 1970 the incoming service is galvanised or lead-era pipe that has corroded from inside; patching it is a short-term fix and a new run of polyethylene or copper to the meter is the real answer.
Some houses have a mains run that goes under the slab, so the choice is between breaking concrete, boring a new line around the house, or running the new pipe along the outside wall. We lay out each option with the cost, the mess and how long you are without water.
Cost guide for 2026
Guides only; every site is different.
- Meter test and basic fixture check: often part of a call-out.
- Electronic leak detection on a private line: commonly a few hundred dollars.
- Repair of a visible accessible section: usually a standard plumbing job with fittings.
- Excavation and repair under paving or concrete: quoted per metre with reinstatement.
- Replacing the whole service pipe from meter to house: often in the low-to-mid thousands, depending on distance and surface.
While you wait for us
- Close the property stop tap, typically at the meter box at the front, and photograph the meter dial. If the dial stops, the leak is downstream of the tap and you have limited damage.
- Open one cold tap at the lowest point in the house to relieve pressure, and keep an eye on the bill-saving dial.
- Do not use the hot water system with no water supply, as an electric element can burn out. Turn it off at the switch until water is restored.
- Photograph wet patches, sunken ground and the meter before and after for any claim or retailer adjustment.
- If water is running toward the house or a power point, turn off the power to that area at the switchboard and call us.
In a cold snap, a stop tap that has not moved in years can seize or snap. Do not force it with a wrench. If it will not turn, call us and we will arrange a control valve or isolate at the retailer’s side. Related: frozen pipes in Melbourne.
FAQ
- Will the retailer pay?
- If it is their asset, they own the repair. If it is yours, they will not. The meter position is the usual split.
- Can I shut the meter overnight?
- Yes if you know how and you have another water plan. Toilets will not refill, and that is the point.
- Is a high bill proof?
- It is a clue. A dripping cistern can also spin a meter. We check fixtures first when the yard is dry.
- Detection cost?
- Quoted. Better than guessing with a five-metre trench.
- Who do I call after hours if the road is flooding?
- If it looks like a burst main in the street, the water authority and, if needed, emergency services. If it is your private line, us.
- Can tree roots cause a mains leak?
- Roots follow water and can crush or split old pipe, but they more often grow into leaking joints than cause the first leak.
Related reading
See plumbing, emergency plumbing, burst pipe shutoff, plumber in Kew and plumber in Glen Iris.
Meter spinning with taps off?
Stop tap in, then detection. We quote digging after we know the line. Call 1300 24 11 47.