A sewer smell in a Melbourne bathroom is one of the more unpleasant plumbing problems to diagnose because the odour alone does not tell you where it is coming from. The source can be as simple as a dry floor drain that needs 2 litres of water, or as serious as a cracked sewer line under the floor. This guide from Steve, our licensed Melbourne plumber, covers the five most common causes, ordered from easiest to most involved, so you can find and fix it in the right order.
⚠ Hydrogen sulphide safety note
Sewer gas is primarily composed of hydrogen sulphide (H₂S) and methane. At low concentrations it causes the characteristic rotten-egg smell and headaches. At higher concentrations in enclosed spaces it is toxic and potentially flammable. If the smell is intense or you feel unwell, ventilate the space immediately and leave. Do not use an open flame or spark in the room. Call a licensed plumber immediately.
Cause 1: Dry P-trap (most common)
Why it happens
Every fixture drain — basin, bath, shower, floor drain, and bidet — has a P-trap: a U-shaped section of pipe that holds a small water seal preventing sewer gas from passing back into the room. If a fixture is not used for 2–4 weeks, the water in the trap evaporates. In Melbourne rentals, holiday homes, secondary bathrooms, and holiday-rental apartments in St Kilda, Carlton, and South Yarra, dry P-traps are the most common cause of a bathroom sewer smell.
The fix
Run water in every fixture in the bathroom for 30 seconds to refill each P-trap. For floor drains that are rarely used, pour 500ml of water slowly down the drain. The smell should resolve within an hour once all traps are refilled. If the smell returns within a few days without the fixture being left unused, the P-trap may be cracked or the drain design may allow too-rapid evaporation.
Cause 2: Blocked or poorly ventilated sewer vent pipe
Why it happens
Every sanitary drain system requires vent pipes that exit through the roof to allow air into the system, preventing siphoning of P-traps and allowing sewer gases to escape above the roofline. In Melbourne terrace houses, Victorian villas, and Edwardian homes in Fitzroy, Collingwood, Richmond, and Carlton, original cast-iron or terracotta vent pipes can collapse, become partially blocked with debris, or have their roof terminations dislodged by possums or storm damage. A blocked vent creates negative pressure in the drain, which can suck water out of nearby P-traps, allowing gas to pass through.
The fix
A licensed plumber can inspect vent pipe terminations from the roof and use a CCTV camera to check internal vent pipe condition. Clearing a debris blockage in the vent is a straightforward job. A collapsed or corroded vent pipe may require excavation or internal repair.
Cause 3: Failed pan collar or loose toilet base seal
Why it happens
The toilet pan sits on a rubber pan collar that seals the connection between the base of the pan and the floor waste connection. Over time — particularly in Melbourne terrace houses where floor-level movement is common in older homes — the pan collar compresses and loses its seal. The toilet may feel slightly loose when sat on, and sewer gas escapes around the base. This is a common cause in bathrooms where the toilet is adjacent to the shower and the smell is strongest near the floor.
The fix
A licensed plumber removes the pan, replaces the pan collar and seals, and re-secures the toilet. This is regulated plumbing work in Victoria and requires a Certificate of Compliance. Cost is typically $150–$350.
Cause 4: Cracked or offset sewer drain under the floor
Why it happens
Melbourne homes built before 1960 commonly have terracotta clay-pipe sanitary drains under the floor slab or under a suspended timber floor. These pipes are susceptible to cracking from ground movement, tree root intrusion, and decades of age. A cracked sewer drain under the bathroom floor allows gas to permeate into the subfloor and rise through gaps in the floor — particularly common in homes with suspended timber floors where there is direct airflow between the subfloor and the room. See our blocked drain Melbourne guide for how root intrusion is diagnosed.
The fix
A CCTV camera inspection of the sanitary drain identifies the crack or offset. Repair options include pipe relining (no-dig) for a crack that is structurally sound, or excavation and replacement for a collapsed or offset section. The VBA’s licensed plumber requirements apply to all repair methods.
Cause 5: Build-up in the drain waste pipe itself
Why it happens
Organic matter accumulation in drain pipes — hair, soap scum, grease — decomposes anaerobically (without oxygen) and produces hydrogen sulphide. A shower drain with a hair blockage that has been present for months can become a localised odour source even if the P-trap is intact. The smell from this source is typically concentrated directly above the drain opening rather than diffusing through the whole room.
The fix
Remove the drain cover and use a drain snake or drain clearing tool to extract organic build-up. For a persistent issue, a hydro jet flush of the drain lines will clear build-up further down the pipe. For shower drains that block repeatedly, a hair trap insert prevents repeat accumulation.
Cost to diagnose and fix a sewer smell in Melbourne 2026
| Issue | Typical repair cost Melbourne 2026 |
|---|---|
| Dry P-trap (refill yourself) | $0 |
| Drain snaking or cleaning (on-site) | $120–$250 |
| Pan collar replacement | $150–$350 (incl. CoC) |
| CCTV sewer line inspection | $250–$450 |
| Vent pipe clearance (roof access) | $200–$400 |
| Pipe relining (per metre) | $300–$600/m |
See our Melbourne plumber cost guide 2026 for call-out and hourly rate detail.
Sewer smell in Melbourne terrace houses and heritage homes
Why older Melbourne homes are more prone
Melbourne’s inner suburbs — Fitzroy, Collingwood, Carlton, Richmond, Prahran, and Brunswick — contain large numbers of Victorian and Edwardian terrace houses with sanitary drainage systems that are over 100 years old. These homes typically have terracotta clay pipe drains, cast-iron vent stacks, and lead-joined pan connections that have been in service since the early 1900s. Ground movement from Melbourne’s clay soils (which expand and contract with moisture changes), combined with tree root intrusion from the established European trees common in these suburbs, creates a higher rate of drain defects than in newer outer-suburban properties. If you are buying or renting in an inner Melbourne suburb, a pre-purchase drain inspection is a worthwhile investment before committing.
Septic vs sewer-connected properties
A small number of Melbourne fringe and rural properties (Templestowe Lower, Eltham, Research, Warrandyte) are still on septic systems rather than connected to Melbourne Water’s sewerage network. A sewer smell from a septic system can indicate a full tank, a failed drainage field, or a blocked inlet pipe. Contact your local council for guidance on septic system inspection requirements. See Melbourne Water for information on sewer connections in fringe areas.
Frequently asked questions
- Why does the sewer smell only appear at night or early morning?
- Temperature and air pressure changes affect sewer gas movement. Cool night temperatures cause air in drain pipes to contract, which can draw gas upward through a marginal P-trap seal. An evaporative cooler or bathroom exhaust fan that creates negative pressure in the bathroom can also draw gas through imperfect seals. If the smell is consistently worse at specific times, it suggests a marginal rather than total P-trap or collar seal failure.
- Is a sewer smell dangerous?
- At the concentrations typically experienced in a bathroom with a dry P-trap or minor seal failure, hydrogen sulphide causes odour and can cause headaches or nausea with prolonged exposure. In very rare cases involving a heavily blocked sewer with gas accumulation, concentrations can reach hazardous levels. If the smell is very strong, immediately ventilate the space, leave the room, and call a plumber. Do not use spark-producing tools in a strongly gas-smelling enclosed space.
- Can I fix a sewer smell myself?
- Refilling a dry P-trap and cleaning an accessible drain are DIY-appropriate. Replacing a pan collar, repairing a vent pipe, or repairing a cracked sewer drain all require a licensed plumber in Victoria, as these are regulated plumbing work under the Plumbing Regulations 2018 (Vic). A Certificate of Compliance is required for pan collar and drain repair work.
Sewer smell in your Melbourne bathroom?
Call 1300 24 11 47 — licensed plumbers diagnose sewer smells and fix the source, dispatched across Melbourne across Melbourne.
Related reading
For local help, see our Melbourne plumbing services, plumber in Richmond, plumber in Brunswick. Our emergency plumber in Richmond page covers scope, pricing and 24/7 dispatch. Emergency? See our emergency plumber in Richmond. Related guides: Bathroom Renovation Plumbing Costs Melbourne: What to Budget per Room, Backflow Prevention Compliance Victoria: What Melbourne Property Owners Need to Know.