Solar inverter on a Melbourne home garage wall
Electrical

Solar panel inverter faults: 6 issues a Melbourne electrician sees most often

Kevin · Licensed Electrician 8 min read

Solar panel inverter faults: what to check

Infographic: Solar panel inverter faults: what to check.

The most common solar inverter fault is a grid disconnect after voltage spike - usually clears with a 5-minute power cycle. Next: overheating in summer (clean fins, shade the inverter); earth/isolation faults from cable degradation; MPPT tracking failure; and finally complete inverter failure. After about year 10, replacement often beats repair on cost - $1,800-$3,800 for a 5-8kW string inverter installed.

Fault 1 - Grid disconnect (most common, easiest fix)

The inverter's job is to feed AC power into the grid at exactly the right voltage and frequency. When the grid voltage spikes (most commonly during heatwaves when nearby solar systems all export simultaneously), inverters disconnect for safety. They usually reconnect after a 5-minute wait once voltage stabilises.

You can try: Switch off the AC isolator next to the inverter (the white switch). Wait 60 seconds. Switch the DC isolator off, then back on. Wait 60 seconds. Switch the AC isolator back on. Inverter should boot through diagnostics and reconnect.

If it keeps disconnecting daily, your grid voltage is sitting above 253V (the legal AS4777 cap). Call your DNSP (Jemena, AusNet, United Energy) - they can investigate and adjust the transformer tap.

Fault 2 - Overheating (shade, cleaning, orientation)

String inverters de-rate (reduce output) above 50°C and shut down above about 60°C. Common Melbourne summer issue. Check:

  • Inverter installed in direct sun? Move or add a shade panel.
  • Heatsink fins clogged with dust/cobwebs? Soft brush clean while OFF.
  • Garage wall install where ambient hits 45°C+? Add vent or relocate.

Service cost: $180-$320 for clean and inspection.

Fault 3 - Earth leakage fault

Inverter reports a "ground fault" or "GFCI" error. Cause: insulation in DC cabling has degraded (sometimes due to rodent damage or UV exposure on the roof). Each panel string is tested with an insulation resistance tester. Faulty cable or panel is identified and replaced.

Cost: $320-$650 diagnosis + repair, depending on whether cable, MC4 connector or panel itself is the cause.

Fault 4 - Isolation fault (DC wiring)

Similar to earth leakage but on the DC side, often presented as "Riso low" or "Isolation Error" on the display. Most common cause: water ingress at a roof junction box or damaged DC cable insulation. Some inverters self-clear during dry weather; persistent faults need repair.

Fault 5 - MPPT tracking failure

MPPT (Maximum Power Point Tracking) is how the inverter finds the optimum operating point of each string. If one MPPT channel fails, the inverter still produces from the other but at reduced output. Check your monitoring app - if one string shows zero or low compared to its pair, that's an MPPT or string fault.

Repair: usually the MPPT board can be swapped on commercial-grade inverters (Fronius, SMA). On residential 5-8kW units, often the whole inverter is replaced as MPPT board cost approaches new inverter price.

Fault 6 - Complete inverter failure (replace vs repair)

Capacitor failure, board failure, transformer failure - all common after 10-12 years. Decision rule:

  • Inverter under 5 years old + still under manufacturer warranty: Warranty claim.
  • Inverter 5-10 years old: Repair if quote is under 40% of replacement.
  • Inverter 10+ years old: Replace. Newer units are more efficient (97-98% vs 94-95%) and have better app monitoring.

When to call an installer vs an electrician

If the system was installed less than 10 years ago and the installer is still trading - call them first. They have warranty obligations and direct manufacturer support. If they've gone out of business (common in solar industry), or your system is older, any A-grade Melbourne electrician with solar accreditation can diagnose and repair.

Cost of solar inverter repair/replacement Melbourne

ServiceCost
Inverter diagnosis call$220-$380
Power cycle + reset + clean$180-$280
DC cable / MC4 connector repair$320-$580
String panel replacement (single)$420-$780
Inverter replacement 5kW$1,800-$2,600
Inverter replacement 8kW$2,400-$3,800
Inverter replacement 10kW + battery-ready$3,200-$5,500
System health check + report$280-$420

FAQ

How long should a solar inverter last?
10-15 years for residential string inverters. Microinverters claim 25 years.
Can I claim STCs on a replacement inverter?
Not on inverter-only replacement. New STCs apply only to new panel installs.
Why is my generation low even though the inverter shows no fault?
Panels degrade about 0.5% per year. Also check for shading from grown trees, soiling (bird droppings, dust), and string mismatch.
What's the warranty on a new inverter?
5-12 years depending on brand. Premium brands (Fronius, SMA, SolarEdge) offer 10+ year warranties; budget brands 5 years.
Should I replace inverter only or upgrade panels too?
If panels are 10+ years and degraded, consider a full system. If panels are still strong - inverter only is cheaper.

For local help, see our Melbourne electrical services, electrician in Glen Waverley and electrician in Hawthorn. Our commercial electrical services page covers commercial solar diagnostics. Sister reads: EV charger home installation Melbourne, whole-home surge protection, and home electrical load calculations. For consumer solar context, see energy.gov.au.

Solar not producing?

Call 1300 24 11 47. Same-week diagnosis. Repair vs replace quoted honestly.

Need a Melbourne electrical technician?

We're one call away — 24/7 emergency service, live answer, upfront pricing.