Water in the ceiling under a shower, or a wet wall in the next room, is often a failed shower membrane — not a dripping mixer. Fresh silicone buys time. It does not replace a membrane that has let go around the waste.
The short version
- Stop using the shower if water is showing through a ceiling or a neighbouring wall.
- Silicone buys time. It is not a membrane repair.
- A leak test by a licensed plumber finds the source before anyone rips out tiles.
- A failed membrane means the shower recess is rebuilt: strip, waterproof, retile.
- Plumbers do the pipes, waste and falls; a waterproofing specialist applies the membrane to the wet-area standard (AS 3740). We coordinate.
Recess leak vs mixer leak vs waste leak
Water in the ceiling under a shower, or a wet wall in the next room, is often a failed shower membrane, not a dripping mixer. Fresh silicone buys time. It does not replace a membrane that has let go around the waste. Related: leaking ceiling from the bathroom.
Sorting the source matters because the fixes are different:
- Mixer or spout leak: water appears on the wall around the tap or behind the escutcheon plate, usually when the shower is running. A washer or cartridge swap is the fix.
- Shower arm or wall joint leak: drip behind the wall that shows with a damp patch on the other side. Needs the wall opened or a re-run of pipework.
- Waste or floor drain leak: the waste seal under the tile is cracked or perished. Water appears under the shower after use, often slowly.
- Membrane failure: water runs through cracked grout and tile into the substrate. Damp grows slowly and may show in a neighbouring room or the ceiling below.
What you can do today
- Turn the shower off and stop using it if there is water inside a wall or ceiling.
- Run a hand over tile edges and grout. Crumbling grout and loose tiles are signs of trouble.
- Check the corners and the base for movement. A soft tile or a spongy floor suggests rotted substrate.
- Put a towel along the base of the neighbouring wall to catch any wicking.
- Take dated photos of the stain and the tile condition. They help insurance and the repair plan.
- Do not seal the whole shower in silicone and keep using it.
How a plumber tests it
We use a staged approach: a visual check, moisture readings on the walls and floor, a pressure test on the hot and cold lines to the shower, then a flood test of the shower base with the waste plugged. Water level is marked and monitored for a set period. If the level drops, the membrane or waste seal is leaking. If the pipes lose pressure, the problem is in the plumbing behind the wall. Where needed, a thermal camera or moisture meter confirms the path of the water.
Repair paths and 2026 guide prices
These are guides only; every bathroom is different.
- Mixer cartridge or washer replacement: typically a few hundred dollars.
- Re-grout and re-silicone where the membrane is intact and the leak is only at the surface: a few hundred dollars, often a decent short-term fix.
- Waste replacement and re-sealing: commonly several hundred to over a thousand dollars, depending on access.
- Full shower strip-out, new membrane, retile and plumbing: a project quote, usually in the low-to-mid thousands, higher for large or heavily tiled showers.
- Ceiling repair and painting below: separate and often needed after a long-term leak.
Related: bathroom renovation plumbing cost and shower and bathroom plumbing.
Why Melbourne showers fail
Older Melbourne homes often have showers with no proper membrane, just sand and cement and tile. Houses from the 1980s and 1990s may have a membrane that has aged and cracked after thirty years of movement. Timber-floor houses flex more than slabs, so a membrane without enough flexibility tears at the corners. Hard water scale on the glass and a loose screen seal, which sends water down the wrong path, speed things up. Poor falls toward the waste leave water pooling in the shower base until it finds a crack.
Insurance and landlords
If the leak has damaged neighbouring rooms, an insurer may cover the resulting damage but not the failed shower itself, and slow, ongoing leaks are often excluded. For rentals, the landlord is responsible for repairs that stop leaks and damage. See rental urgent repairs in Victoria. Keep our report: it documents the cause and date.
Signs the damage has spread
Look for paint bubbling on the wall opposite the shower, a ceiling stain in the room below, a musty smell in a cupboard, swelling at skirting boards, or doors that start to stick. A moisture meter helps us find the extent without breaking surfaces. If the leak has been running for months, timber studs and floor sheeting may be affected. We note the extent before the quote so there are no surprises when the old wall comes off.
FAQ
- Can I still shower if I squeegee the floor?
- If the leak is at the surface, short-term maybe. If water is showing in a ceiling or the next room, stop using it. Squeegeeing does not stop water going through a cracked membrane.
- Is mould on the ceiling a plumbing or plaster issue?
- It is a moisture problem first. Plaster and paint come after the leak is fixed. Exhaust fan performance matters too. Related: bathroom exhaust vs heat lamp.
- Will a ready-made acrylic tray fix an old tiled recess?
- It can replace a failed tiled base, but walls and plumbing still need checking. We assess the wall condition first.
- Does the plumber or a tiler own the membrane?
- Membrane work is a specialist job done to the wet-area standard. We coordinate plumber, waterproofer and tiler so one party is accountable at each step.
- Suburbs with lots of these?
- Older timber-floor homes in Northcote, Hawthorn, Brunswick and Richmond; 1990s units in Box Hill and Doncaster.
- How long does a shower rebuild take?
- Usually five to ten working days, mostly curing time between waterproofing and tiling.
Related reading
See plumbing, leak detection and repair, shower drain blocked, plumber in Hawthorn and plumber in Box Hill.
Stain under the shower?
We test before anyone breaks tiles. Call 1300 24 11 47.