Relining wins when the existing pipe is structurally sound, the diameter is 100mm+, the route is straight enough, and you want to avoid digging up a driveway or garden. Dig-and-replace wins when the pipe has collapsed, the diameter is too small (80mm or less), there are severe offset joints, or replacement is cheaper because the trench is already open. Per metre: relining $400-$650; dig-and-replace $250-$550 in soft ground, $700-$1,400 through concrete.
What pipe relining is (CIPP process explained)
CIPP - Cured-In-Place Pipe - is a trenchless repair technique. A flexible liner saturated in epoxy resin is pulled or inverted into the existing pipe through an access point (an inspection pit, an external drain access, or a temporary cut). It's inflated against the inside wall and cured with hot water, steam, ambient air, or UV light. Once cured, the liner becomes a structural "pipe within a pipe" that's smooth, jointless, and rated for 50+ years.
What dig-and-replace involves
The traditional method: excavate down to the faulty pipe, cut out the bad section, lay new PVC or HDPE, backfill, restore the surface (concrete, paving, landscaping). Necessary when the pipe is too damaged to host a liner.
5 factors that determine which method wins
- Pipe condition: If the pipe is collapsed or has lost more than 25% of its host wall, dig-and-replace.
- Pipe diameter: Relining needs 100mm+ for residential sewer; smaller pipes (80mm stormwater) usually dig.
- Route: Severe offsets, 90° bends close together, or extreme dips usually mean dig.
- Surface above: Driveway, footpath, mature garden, heritage paving - all push toward relining.
- Access points: Relining needs a pull-in access and a take-up point. If neither exists, the cost of creating them can erase the dig savings.
Cost comparison table
| Scenario | Relining | Dig-and-replace |
|---|---|---|
| 10m sewer under garden bed | $4,200-$6,500 | $2,500-$5,500 |
| 10m sewer under concrete driveway | $4,200-$6,500 | $8,000-$14,000 |
| 5m branch line | $2,400-$3,800 | $1,800-$3,200 |
| 15m sewer through heritage tile | $6,300-$9,800 | $10,000-$18,000 |
| Junction repair (single) | $1,200-$2,400 | $1,800-$3,800 |
| CCTV inspection (always pre-job) | $280-$450 | $280-$450 |
When relining isn't possible
- Complete pipe collapse - no host for the liner
- Pipe diameter under 80mm
- Severe offset joints (more than 25% lateral displacement)
- Sharp 90° turns within 1m of each other
- Sections of pipe with multiple branch take-offs in close proximity
- Pipe material that can't host an epoxy (rare in Melbourne - earthenware, cast iron and PVC all reline well)
Melbourne clay soil and root intrusion - extra context
Melbourne's heavy clay soil moves seasonally - wet winters expand it, dry summers shrink it. Older earthenware sewers laid before the 1970s often have hairline cracks at joints. Trees seek that moisture and roots penetrate through the cracks. Once roots are inside, they expand and eventually fracture the pipe.
CIPP eliminates the joints (it's one continuous lining), so root re-entry is prevented for the lining's life. Dig-and-replace with HDPE achieves the same outcome by using fewer, fully sealed joints.
Warranty differences - relining vs replacement
| Method | Workmanship warranty | Material warranty | Practical life |
|---|---|---|---|
| CIPP relining (reputable installer) | 10 years | 25-50 years | 50+ years |
| PVC dig-and-replace | 5-10 years | 50+ years | 50+ years |
| HDPE dig-and-replace | 10 years | 50+ years | 100+ years |
| Spot repair (clamp) | 1-2 years | 5-10 years | Temporary |
How 24/7 Service Mate quotes pipe repair
CCTV first - always. We do not commit to relining or dig-and-replace until you've seen the footage and understand the condition. The CCTV report doubles as a "before" record if there's later dispute with insurance or strata. Where dig-and-replace makes economic sense, we say so - even though relining margins are higher. The most expensive option is the one you have to redo in 18 months because the wrong method was chosen.
Terracotta pipes in Melbourne inner suburbs
Why so many Melbourne homes have terracotta drain pipes
Homes built across Melbourne’s inner suburbs — Fitzroy, Collingwood, Richmond, Albert Park, Prahran, Northcote, Brunswick — from the 1880s through to the 1960s were predominantly plumbed with vitrified clay (terracotta) drainage pipes. These pipes were the industry standard of their era, durable when installed correctly, but brittle by today’s standards. After 50–80 years in Melbourne’s reactive clay soil, they are highly vulnerable to root intrusion, offset joints, and crack failure.
The good news: vitrified clay is one of the best candidates for CIPP relining. The smooth internal lining bonds well to the clay host pipe and effectively bridges cracked sections, offset joints, and root entry points without excavation.
How Melbourne’s reactive clay soil affects your pipes
Melbourne sits on a band of reactive clay soil that expands when wet and contracts when dry — the same reason Melbourne footpaths buckle and house foundations move. Underground drain pipes in this soil experience constant seasonal movement. Over decades, this movement causes offset joints (pipe sections shift sideways at collar joints), root bridges (tree roots from Melbourne’s street plane trees, elms, and liquid ambers exploit hairline cracks), and bellied pipes (a section sags, creating a low point where solids accumulate).
A CCTV drain inspection identifies which failure mode you have — offset joints and root intrusion are reliably reline-able, while severe bellying usually requires dig-and-replace of the bellied section only.
Does home insurance cover drain pipe repair?
Most Australian home building insurance policies cover sudden and accidental damage to underground pipes but not gradual deterioration or maintenance failures. A collapsed drain caused by a sudden root breakthrough may qualify, while gradual root intrusion is typically excluded as a maintenance item. The CCTV report your plumber provides is critical documentation for any insurance claim. Call your insurer before authorising work if the damage was sudden. 24/7 Service Mate can provide a written CCTV report and quote on letterhead to support your claim.
What the quote process looks like
24/7 Service Mate quotes pipe relining in two stages: first a CCTV inspection ($220–$350) to assess extent and pipe condition, then a fixed-price relining quote based on the footage and diameter. If you proceed with relining, the CCTV inspection fee is credited against the relining cost. This means you never pay twice for the diagnosis.
FAQ
- How long does pipe relining take?
- Most residential jobs: 1 day on site for under 20m. Curing typically 2-4 hours.
- Can I use the toilet during relining?
- No - the sewer is offline for 6-10 hours from liner insertion to full cure.
- Does relining reduce pipe diameter?
- Yes, by 3-5mm wall thickness. Smoother surface offsets the loss; flow capacity actually increases or matches the original in most cases.
- Will insurance cover relining or replacement?
- If the damage is sudden and accidental (e.g. tree fell, struck pipe), yes. Gradual root or wear is generally excluded. Check your PDS.
- Is relining DIY?
- No. CIPP installation requires a licensed drainer, specialised equipment, and a permit for connection back to the main if it's a shared sewer.
Related reading
For local help, see our Melbourne plumbing services, plumber in Brunswick and plumber in Carlton. Our blocked drain clearing page covers CCTV diagnosis and root cutting. Sister read: blocked drain DIY vs CCTV.
Need pipe repair quote?
Call 1300 24 11 47. CCTV inspection first, honest reline vs dig advice.