Licensed Melbourne HVAC technician at an indoor split system
Heating & Cooling

Air conditioner not turning on in Melbourne? 8 checks before you book a tech

Andy · Licensed HVAC Technician 5 min read

If the split or ducted system will not start, work through power and the isolation switch before you assume a dead compressor. Do not keep hammering the remote. If the outdoor unit clicked and then went silent with a burning smell, leave it off.

The short version

  • Confirm the indoor display has power. A blank wall controller often means a tripped circuit, not a dead AC.
  • Check the outdoor isolation switch — the weatherproof rotary beside the condenser. Storms knock these off.
  • Replace remote batteries and point it at the indoor unit, not the TV.
  • One reset of a tripped safety switch is enough. If it returns, stop.
  • Ice, burning smell, or a condenser that hums but will not spin is a licensed tech job — no refrigerant DIY.

Blank indoor unit vs unit that beeps and dies

A completely dead indoor head with no LEDs is usually power: a tripped RCBO, a flicked isolation switch, or a failed plug-in for a portable. A unit that beeps, shows a code, then stops is a control or outdoor fault. Write the code down. Daikin, Mitsubishi and Fujitsu codes are useful; we still test rather than guess from a sticker.

Spring in Melbourne is when people first try cooling after a winter on heat. Isolation switches get bumped by gardeners. Outdoor breakers trip in rain. This is the season those two checks save a wasted callout — and also the season a seized outdoor fan looks identical until someone opens the isolator.

The eight checks, in order

1. Wall controller batteries or lost settings. Some ducted controllers reboot to off after a blackout. 2. Indoor circuit at the switchboard. 3. Outdoor isolator. 4. Safety switch. Reset once. 5. Timer or off-peak setting left from winter. 6. Child lock on the remote. 7. Filter so clogged the indoor coil iced and the unit locked out. 8. Visible outdoor damage — bent fan, possum nest, flood debris.

If checks 1–6 are clean and it still will not start, book. Do not take the outdoor covers off. Capacitors hold charge. Refrigerant handling needs ARC licensing.

When it is urgent

Burning smell at the indoor or outdoor, scorching on the isolator, water dripping into the indoor electrics, or a unit that trips the whole house — those are electrical as much as HVAC. We coordinate rather than tell you to wait for a cooler day.

Cost guide: a no-start diagnosis on a split is often a standard service call. Capacitor, board or compressor repairs are quoted once we know which. You approve before parts go in. Related: why AC stops cooling in summer.

Reading the lights and codes

Most split systems tell you something even when they will not run. A flashing green or red LED, a pattern of blinks on the indoor head, or an error code on a wall controller points toward the fault family. Typical groups we see:

  • Communication fault between indoor and outdoor: a loose terminal, a chewed cable or a failed board.
  • Outdoor unit protection: overload, high pressure, low pressure or an overheating compressor.
  • Sensor fault: a thermistor reading out of range, often after water or insect ingress.
  • Drain or float switch fault: a full condensate tray on a ducted or cassette unit shuts the system down on purpose.

Photograph the code and the LED pattern before you switch anything off. A 30-second video on your phone helps us bring the right parts.

Power problems that look like AC problems

A split system should be on its own dedicated circuit. When a unit will not start, it is often because that circuit has tripped or because a safety switch has taken it out. A dedicated circuit that trips every time the compressor starts can mean a failing compressor, a bad capacitor or a loose connection at the board. If other lights or powerpoints are also off, the cause may be your switchboard, not the air conditioner. In that case, see no power in the whole house and tripped switchboard that won’t reset.

If you smell a hot, fishy or burnt smell near the indoor head, outdoor unit or isolator, turn off the circuit at the switchboard and leave it off. That is an electrical fault.

The Melbourne season pattern

We get a spike in no-start calls on the first warm weekend of spring and again at the first heatwave. Reasons: owners restart a unit that has not been touched for six months, summer storms trip circuits, gardeners knock isolators, and units with hidden faults reveal them as soon as they are asked to cool. A pre-summer service catches many of these in advance. See how often to service aircon and pre-summer checklist.

What a licensed technician does

We start with power: voltage at the isolator, at the outdoor terminals, and at the indoor board. We then check communication, capacitor values, contactor and compressor windings, and the fan motors. Refrigerant pressures come after, not before. Where the fault is electrical, our team holds the electrical licence to repair it. Where it involves refrigerant, our technicians hold an ARC licence. You approve the repair quote before parts are fitted, and old parts can be shown to you.

If your unit is under warranty, check the terms before a third party opens it. We will tell you if a call to the manufacturer first makes sense.

Repair or replace?

A capacitor or a contactor is a modest repair on almost any age of unit. A main board, a fan motor or an indoor coil is a bigger decision on a system older than eight to ten years. A failed compressor in an old, out-of-warranty split usually tips the balance toward replacement, particularly if the system uses an older refrigerant. We give you a comparison, not a pitch. See split system installation cost and R32 refrigerant changes.

FAQ

The remote light works but the AC does not. Dead indoor?
Not always. The indoor may have lost power or the indoor-outdoor communication cable is open.
Can I reset it at the outdoor isolator every time it fails?
No. Repeated trips mean a fault. Isolating is for service, not a daily ritual.
Is a heatwave a reason to keep restarting?
Restart once after a blackout. If it faults again, running it risks the compressor.
Do you work on evaporative as well as refrigerated?
Yes. Start-up after winter is a different checklist — we cover that in a later guide this month.
Which suburbs for same-day no-cool calls?
Greater Melbourne. Dandenong, Glen Waverley and the inner south are regular no-start runs in spring.

See Melbourne HVAC services, emergency HVAC repair, HVAC in Dandenong and HVAC in Glen Waverley. Also thermostat not working.

Split or ducted will not start?

ARC-licensed techs, written quote before parts. Call 1300 24 11 47.

Need a Melbourne heating & cooling technician?

We're one call away — 24/7 emergency service, live answer, upfront pricing.